Troubleshooting; Fault Code - Meec Tools Rmc300E20V Übersetzung Der Originalanleitung

8

Troubleshooting

Fault code

F1
E1
E2
E3
E4
E5
E6
Cause
The rain delay is activated.
There is no signal from the perimeter
wire.
The wheel motor is blocked.
The rotor is blocked.
The obstruction sensor is not reset.
The product is lifted off the ground.
The rollover sensor is activated.
Task
No action is required.
Make sure that the product is in the
mowing area.
Make sure that the power adapter is
correctly connected to the charging
station and a power outlet that
works.
Change positions of the ends of the
perimeter wire in the terminals at the
rear of the charging station.
Push the power switch to stop the
product and move it to an area
where there are no obstacles. Then
start the product.
Push the power switch to stop the
product. Turn it upside down and
remove the blockage. Turn the
product upright and start it.
Push the power switch to stop the
product and put the product in the
mowing area. If the error code
continues to be displayed, make sure
that the power adapter is correctly
connected to the charging station
and a power outlet that works.
Change positions of the ends of the
perimeter wire in the terminals at the
rear of the charging station.
Push the power switch to stop the
product and move it to an area
where there are no obstacles.
Remove the floating cover and make
sure that its cylindrical magnets can
move freely. Remove any obstructing
objects, attach the cover, and start
the product.
Push the power switch to stop the
product and move it to an area
where there are no obstacles. Then
start the product.
Push the power switch to stop the
product. Turn it upside down and
remove blockages that prevents the
front wheels axle to move freely.
Turn the product upright. Start the
product.
EN
SV
NO
PL
DE
FI
FR
NL
15