GRAPHITE 58GE142 Benutzerhandbuch Seite 11

damaged. Also ensure that the surfaces of the outer flange and inner
flange are clean.
• Use the quick-action flange only with abrasive and cutting discs. Use
only undamaged and properly functioning flanges.
PROPER BATTERY HANDLING AND OPERATION
• The battery charging process should be under the control of the
user.
• Avoid charging the battery at temperatures below 0 C.
• Only charge the batteries with the charger recommended by the
manufacturer. The use of a charger designed to charge a different
type of battery poses a risk of fire.
• When the battery is not in use, keep it away from metal objects
such as paper clips, coins, keys nails, screws, or other small
metal items that can short-circuit the battery terminals. Short-
circuiting the battery terminals can cause burns or fire.
• In the event of damage and/or misuse of the battery, gases may
be released. Ventilate the room, consult a doctor in case of
discomfort. The gases may damage the respiratory tract.
• Fluid leakage from the battery can occur in extreme conditions.
Liquid leaking from the battery can cause irritation or burns. If
a leak is detected, proceed as follows:
• Carefully wipe off the liquid with a piece of cloth. Avoid contact of
the liquid with the skin or eyes.
• if the liquid comes into contact with the skin, the relevant area on the
body should be washed immediately with copious amounts of clean
water, or neutralise the liquid with a mild acid such as lemon juice or
vinegar.
• if the liquid gets into the eyes, rinse them immediately with plenty of
clean water for at least 10 minutes and seek medical advice.
• Do not use a battery that is damaged or modified. Damaged or
modified batteries may act unpredictably, leading to fire, explosion
or danger of injury.
• The battery must not be exposed to moisture or water.
• Always keep the battery away from a heat source. Do not leave it in
a high temperature environment for long periods of time (in direct
sunlight, near radiators or anywhere where the temperature exceeds
50°C).
• Do not expose the battery to fire or excessive temperatures.
Exposure to fire or temperatures above 130°C may cause an
explosion.
NOTE: A temperature of 130°C can be specified as 265°F.
• All charging instructions must be followed, and the battery must not
be charged at a temperature outside the range specified in the rating
table in the operating instructions. Charging incorrectly or at
temperatures outside the specified range can damage the battery
and increase the risk of fire.
BATTERY REPAIR:
• Damaged batteries must not be repaired. Repairs to the battery
are only permitted by the manufacturer or an authorised service
centre.
• The used battery should be taken to a disposal centre for this
type of hazardous waste.
SAFETY INSTRUCTIONS FOR THE CHARGER
• The charger must not be exposed to moisture or water. The
ingress of water into the charger increases the risk of shock. The
charger may only be used indoors in dry rooms.
• Unplug the charger from the mains before carrying out any
maintenance or cleaning.
• Do not use the charger placed on a flammable surface (e.g.
paper, textiles) or in the vicinity of flammable substances. Due
to the charger's temperature increase during the charging process,
there is a danger of fire.
• Check the condition of the charger, cable and plug each time
before use. If damage is found - do not use the charger. Do not
attempt to disassemble the charger. Refer all repairs to an
authorised service workshop. Improper installation of the charger
may result in a risk of electric shock or fire.
• Children and physically, emotionally or mentally challenged
persons, as well as other persons whose experience or knowledge
is insufficient to operate the charger with all safety precautions,
should not operate the charger without the supervision of a
responsible person. Otherwise there is a danger that the device will
be mishandled resulting in injury.
• When the charger is not in use, it should be disconnected from
the mains.
• All charging instructions must be followed, and the battery
must not be charged at a temperature outside the range
specified in the rating table in the operating instructions.
Charging incorrectly or at temperatures outside the specified range
can damage the battery and increase the risk of fire.
CHARGER REPAIR
• A defective charger must not be repaired. Repairs to the charger
are only permitted by the manufacturer or an authorised service
centre.
• The used charger should be taken to a disposal centre for this
o
type of waste.
• ATTENTION: The device is designed for indoor operation.
• Despite the use of an inherently safe design, the use of
safety measures and additional protective measures, there
is always a residual risk of injury during work.
Li-Ion batteries can leak, catch fire or explode if they are heated
to high temperatures or short-circuited. Do not store them in
the car during hot and sunny days. Do not open the battery
pack. Li-Ion batteries contain electronic safety devices which,
if damaged, can cause the battery to catch fire or explode.
PICTOGRAMS AND WARNINGS
1.Read the operating instructions, observe the warnings and safety
conditions contained therein.
2.Wear safety goggles and ear protection and a protective mask.
3.Wear protective gloves.
4.For indoor use, protect from water and moisture.
5.Disconnect from power supply before repair and maintenance.
6.Keep children away from the appliance.
7.Risk of losing fingers, use caution.
8.Protect from rain.
9.Do not throw the cells into water, they pose a risk to the aquatic
environment.
10.Do not throw cells into fire
11.Do not allow the cells to get hotter than 50°C
12.Do not dispose of with household waste.
13.Recyclable and selectively collected.
DESCRIPTION OF THE GRAPHIC ELEMENTS
The following numbering refers to the components of the device
shown on the graphic pages of this manual.
Designation Fig. A
Designation Fig. B
11
1 Spindle lock button
2 Switch
3 Main handle
4 Control panel
5 Battery socket
6 Blade guard lock
7 Shield mounting flanges
8 Shield
9 Additional handle
Description
1 Switch in the on position (I)
2 Switch in the off position (0)
3 Battery charge status indicator
Description