MasterCool COMMANDER1100 Bedienungsanleitung Seite 23

Graphic and % of vacuum completed.
•
Time in minutes and seconds of completed vacuum.
•
Total vacuum time programmed.
•
Amount of vacuum leak test time if 10 minutes or more were programmed.
•
Current vacuum pressure
•
Automatic Leak Check Passed
The screen display will go back to blue and continue with remaining vacuum time programmed if
•
vacuum leak test is passed.
If the vacuum leak test failed, LEAK TEST FAILED will be displayed. The machine will terminate the
•
vacuum process
After vacuum leak check is passed, automatic oil inject will be displayed.
Automatic Oil Inject (COMMANDER2100 (-E) ONLY)
A graphic of a hermetically sealed oil bottle as it injects the fresh oil
•
Amount of oil as it is injected
•
Oil bottle that was chosen (#1 or #2)
•
Total oil to be injected
•
Total oil remaining in oil bottle selected (#1 or #2)
•
NOTE: Caution will be displayed if the available oil in bottle selected (#1 or #2) does not contain enough
oil to match the waste oil recovered. Regularly check and fill fresh oil bottles.
1. Turn the red and blue couplers completely counterclockwise and disconnect.
2. Find the leak and repair the system.
3. If refrigerant was used to find the leak, perform automatic or manual procedure
again to remove any refrigerant in system. Repair the leaks
4. Perform vacuum and vacuum leak check again.
www.mastercool.com
COMMANDER2100 screen
COMMANDER2100 screen
23