MasterCool COMMANDER1100 Bedienungsanleitung Seite 20

HOSE FLUSH (COMMANDER3100 (-E) only): This process will flush the machine of any residual oil
•
that is not compatible with hybrid R134a systems. Follow the instructions on the screen
1.
2.
3.
4.
5.
6.
RECOVERY: This procedure is preprogrammed. It cannot be changed in automatic mode.
•
VACUUM: To set the desired amount of vacuum time, press the >> to the right. Set vacuum time on the
•
keypad, press << to lock in time.
LEAK TEST: Vacuum leak testing is available when the vacuum time is 10 minutes or longer. Set the
•
amount of time the leak test will run. Set the time at which the leak test should start.
OIL INJECT (COMMANDER2100 (-E) ONLY): Press the >> to set the desired amount of oil on the
•
keypad. There are three options for oil injection:
o
o
o
Press << to lock in the oil charge.
NOTE: The caution symbol will appear if the amount programmed exceeds the amount of oil available.
20
Connect the red and blue hoses to the flush / storage fittings on the side of the machine.
Open the couplers by turning the knobs clockwise.
Open the red and blue valves on the machine. Press next.
The flush cycle will now be performed.
Flush complete will be displayed when finished .
Disconnect couplers and attach them to the vehicle AC system.
Automatic will inject the same amount of fresh oil that was recovered.
Manual allows for pre-setting the amount of desired fresh oil, regardless of the amount of
oil recovered, use the keypad to set the amount.
Disabling will turn off the oil injection function so that no oil is injected, regardless of the
amount of oil recovered. Press the round blue check button to turn it grey. Press this button
again to enable the function and turn it blue.
www.mastercool.com
COMMANDER3100 screen
COMMANDER2100 screen