Adjusting The Position Of An Existing Start Id - Sony PCM-R300 Bedienungsanleitung

3
Press 0 (REW) or ) (FF) to move the
beginning of the repeated portion.
Each time you press the 0 (REW) or ) (FF)
button, the beginning of the repeated portion shifts
backwards or forwards in 0.3-second increments,
up to a maximum extent of about 2 seconds (4
seconds in long-play mode) in either direction.
When writing a start ID
Position where the ID REHEARSAL
button is pressed in step 2.
.
3 seconds
0.3 sec
Movement with
0.3 sec
each press of
0 (REW)
When writing a skip ID or an end ID
Position where the ID REHEARSAL
button is pressed in step 2.
3 seconds
0.3 sec
Movement with
0.3 sec
each press of
0 (REW)
The time in the display shows the shift in position
from the time the ID REHEARSAL button was
pressed.
Example: Positioning Start ID
After pressing ) (FF) twice
After pressing 0 (REW) twice
4
Repeated portion
Movement with
each press
of ) (FF)
.
Adjusting the Position of an
Repeated portion
Existing Start ID
You can adjust the position of previously recorded
Movement with
start IDs.
each press
of ) (FF)
1
2
0 6 . S
START ID
0 6 .
S
START ID
3
Notes
• Start IDs written within 10 seconds from the end of the
• Existing skip IDs or an end ID cannot be moved.
Writing Sub Codes
Press WRITE to write the ID.
"(WRITE)" appears in the display while the deck
rewinds to the point where you pressed the button,
and then "ID WRITE" appears for a few seconds
and the ID is written on the tape at the selected
position.
• Start IDs are 9 seconds long starting from the
beginning of the repeated portion.
• Skip IDs are 1 second long starting from the end
of the repeated portion.
• An end ID is 9 seconds long starting from the
end of the repeated portion.
Newly written IDs positioned by the Rehearsal
function
Repeated portion
n Tape direction
Start ID
Skip ID
End ID
INPUT AMS REW FF MODE RESET
= + 0 )
SELECT DATA MENU ENTER
ANALOG OPT COAXIAL
STOP PLAY PAUSE REC MUTING REC
POWER
p " P R r
ID MODE
Set ID MODE to START.
During playback, press ID REHEARSAL when the
existing start ID you want to reposition is
displayed.
The deck rewinds to the beginning of start ID and
Rehearsal repeats a 3-second portion.
Do steps 3 and 4 of "Accurate positioning of sub
codes (Rehearsal function)" on this page.
You can move the start ID to a maximum extent of
about 2 seconds (4 seconds in long-play mode) in
either direction from its original position.
tape may be difficult or impossible to move.
9 seconds
1 second
9 seconds
REC LEVEL
MARGIN ID
5
RESET AUTO RENUMBER REHEARSAL 4 6
3 7
g
2 8
WRITE ERASE
1 9
0 10
CH-1 (L) CH-2 (R)
ID MODE REC MODE SBM PHONES PHONE LEVEL
STANDARD
START 48 kHz
OPEN/CLOSE ON
STOP 44.1kHz
6
OFF
END LONG
MIN MAX
ID REHEARSAL
EN
17