Progress PBN13002X Benutzerinformation Seite 14

5. Turn the fasteners by 90° and remove
them from their seats.
6. First lift carefully and then remove the
glass panel.
1
7. Clean the glass panels with water and
soap. Dry the glass panels carefully. Do
not clean the glass panels in the
dishwasher.
10. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
10.1 What to do if...
In any cases not included in this table please
contact an Authorised Service Centre.
14 ENGLISH
90°
2
8. After cleaning, install the glass panel and
the oven door.
If the door is installed correctly, you will hear
a click when closing the latches.
When installed correctly, the door trim clicks.
Make sure that you install the internal glass
panel in the seats correctly.
9.5 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
Back lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Problem
The appliance does
not heat up.
A
Cause and reme‐
dy
The fuse is blown.
Make sure that the
fuse is the cause of the
malfunction. If the
problem persists, con‐
tact a qualified electri‐
cian.