Winding Up The Spool; General Maintenance Work; Removing Blockages; Transport - Parkside Performance Ppfsa 40-Li B2 Originalbetriebsanleitung

•­ After­every­trimming­session,­remove­
grass and soil from the protective cover
and the trimming assembly.
•­ Be­careful­with­the­line­cutter.­It­can­
cause serious lacerations.

Winding up the spool

As­an­alternative­to­a­new­spool,­you­can­
purchase­a­2.4­mm-thick,­5­m-long­nylon­
thread in specialist shops and wind this
yourself onto the spool.
The groove (34) on the spool (33) is
used to clamp the nylon thread so
that it does not unwind by itself.
1. Pull the new line through both line
outlet loops (32) of the spool cap (15).
Make sure that the two arrows point
directly at each other.
2. Make a longitudinal adjustment with
both ends of the line so that the spool
cap (15) is positioned at about the cen-
tre.
3. Turn the rotary knob (15a) in the di-
rection of the arrow indicated on the
bottom of the spool cap (15) to wind
the line onto the spool (33). Winding
is easier if you apply pressure to the
rotary knob (15a) while turning it.

General maintenance work

•­ Check­the­appliance­before­each­use­
for­obvious­defects­such­as­loose,­worn­
or damaged parts.
•­ Check­the­covers­and­protective­devic-
es­for­damage­and­correct­fit.­Replace­
these if necessary.
Check­the­line­cutter­(26).­Never­
use the device without a line cutter
or­with­a­defective­line­cutter.­If­the­line­cut-
ter­is­damaged,­be­sure­to­contact­one­of­
our customer service centres.

Removing blockages

Switch the device off and re-
move both batteries before
you work on the cutting unit.
Wear protective gloves in order to
avoid cutting yourself.

Transport

•­ When­it­is­being­transported,­the­de-
vice must be switched off and the bat-
teries removed.
•­ Carry­the­device­with­one­hand­on­the­
upper shaft tube and the other hand on
the­lower­shaft­tube­(3+6),­in­order­to­
avoid coming into contact with danger-
ous parts when transporting it (e.g. hot
engine,­cutting­unit).
• Use the transport protection when trans-
porting and storing the blade.
•­ Keep­a­safe­distance­from­other­people­
when transporting the device.
•­ When­transporting­the­device,­secure­
it against slipping with tension belts
to prevent injuries and damage to the
device.

Storage

•­ Clean­and­maintain­the­2-in-1­battery­
trimmer 40V before storage.
• Use the transport protection when sto-
ring the blade.
• Store the trimmer in a dry place well
out of reach of children.
• Do not stand the trimmer on its protec-
tive cover. Suspend it by its upper han-
dle in such a manner that the protective
cover does not come into contact with
GB MT
57