Assembling Instructions; Connecting The Shaft Tubes; Mounting The Protective Cover; Mounting The Handles - Parkside Performance Ppfsa 40-Li B2 Originalbetriebsanleitung

GB MT
manufacturer of their medical
implant before operating the
machine.
Observe the safety in-
formation and notes on
charging and proper
use as shown in the
instruction manual
for your battery and
charger from the
X 20 V Team series. A
detailed description of
the charging process
and further information
can be found in the sep-
arate operating instruc-
tions.

Assembling instructions

Remove the rechargeable bat-
tery from the device before
assembly. Insert the recharge-
able battery only once the de-
vice is completely assembled.
There is a risk of injury!
Connecting the shaft
tubes
1. Loosen the shaft tube mounting screw
(23) on the upper shaft tube (3).
2. Push the lock (24) and slide the lower
shaft tube (6) as far as it goes into the
upper shaft tube (3).
3. Turn the lower shaft tube (6) with a
gentle rotating movement until the lock
(24) clicks into place in the bore on the
upper shaft tube (3).
4. Tighten the shaft tube mounting screw
(23) back into place by hand.
50
­ B efore­you­start­the­device,­make­
sure­that­the­lower­shaft­tube­is­firm-
ly and securely in place and locat-
ed in the correct position.
Dismantling:
1. Release the shaft tube mounting screw
(23).
2. Push the lock (24).
3. Pull apart the shaft tubes (3 + 6).
Mounting the protective
cover
Never use the device without
the protective cover properly
mounted. There is a risk of injury.
1. Position the protective cover (7) on the
shaft mount (27).
2. Attach the protective cover (7) using
the­multi-function­key­(18)­and­the­two­
small screws (25).

Mounting the handles

1. Loosen the star screw (30) and remove
the handle mount (29) from the upper
shaft tube (3).
2. Place the multifunction handle (8) and
handle (5) into the receptor (28) on the
upper shaft tube (3). Make sure that the
plastic­ring­is­positioned­exactly­in­the­
guide.
3. Fasten the handles (5 + 8) to the han-
dle mount (29) and star screw (30).
Tighten the star screw (30) by hand.
4. Fasten the device cable to the cable
holders (4).