Charging The Battery; Putting The Shoulder Strap On; Switching On And Off - Parkside Performance Ppfsa 40-Li B2 Originalbetriebsanleitung

GB MT

Charging the battery

­If­warm,­allow­the­battery­to­cool­
before charging.
­Charge­the­battery­(20)­when­only­
the­red­LED­on­the­charge­level­in-
dicator (14) is illuminated.
1.­ If­necessary,­remove­the­battery­(20)­
from the device.
2. Slide the battery (20) into the charging
slot of the charger (21).
3. Plug the charger (21) into a socket.
4.­ Once­charging­is­complete,­disconnect­
the charger (21) from the mains supply.
5. Remove the battery (20) from the
charger (21).

Putting the shoulder strap on

Always wear the shoulder
strap when working with the
device. Always turn the device off
before taking off the shoulder
strap. Accident hazard.
In a hazardous situation, press on
either side of the quick release de-
vice (see ) to clear the quick
release device.
1. Put the shoulder strap (22) on.
2. Adjust the length of the strap so that
the­snap­hook­is­approximately­10­cm­
below your hip.
52
The shoulder strap
is equipped with a
quick release de-
vice so that the
device can be re-
leased quickly
from the shoulder
strap in a dange-
rous situation.
3. Attach the snap hook to the eyelet (12)
on the shaft tube of the device. Unhook
the device before starting the engine
and fasten it to the carrying harness
once the engine is running. Place the
body protection on your hip between
your body and the device.

Switching on and off

The device may only be used with
two­batteries­of­the­Parkside­X 20 V­
Team series.
­ Ensure­your­stance­is­stable­and­
hold the appliance tightly with both
hands and away from your body.
Before­switching­the­device­on,­
make sure that it is not touching any
objects.
Switching on
1. First press the on/off switch (13) to acti-
vate the device.
The current speed preselection
(level 1/2/3) is indicated by
the small lamp lighting up. Se-
lect the desired speed by pressing the
button (9).
2. Operate the switch lock (11) and then
press the start lever (10).
The device starts at the preselec-
ted­speed,­but­reduces­the­
speed­to­ECO­mode­(3500­rpm­
)­at­low­load.­Under­load,­the­speed­
automatically increases again to the
previously selected level.
3. Release the switch lock (11).
The device cannot be switched to
continuous operation.
Switching off
1.­ To­switch­off,­let­go­of­the­start­lever­
(10).