DR.ÖTEK MT-XR Benutzerhandbuch Seite 7

device away from your shoes while walking. The device may detect the
metals on you or inside your shoes as targets.
●The depth indication is accurate for coin-sized objects. Large objects
or irregularly-shaped objects will reduce accuracy.
●Most valuable metal objects will send consistent signals. If the signal
isn't consistent, it will mostly be a false signal.
●The LCD Panel will automatically turn off every 10 minutes. Hold the
'VOL' button for 2 seconds to illuminate it again.
●If the pinpoint mode malfunctioned, sending a signal even when not
close to any metal, lift the detector in the air, press the P-P button once
to solve the problem.
●Please note that the metal detector may not accurate when detecting
the stainless steel, alloy, for the composition of the stainless steel and
the alloy is complicated, which may give false signals. Besides, it can't
detect lead or diamond.
TIPS
●When it is unable to avoid interference around, please try to reduce
the sensitivity appropriately.
●Randomly beep when power on, please try to hold up the coil to the
sky for a while to eliminate the random noise.
●Detection on the beach: The search coil is waterproof and can be
used in shallow water. The composition of seawater is more complex,
to avoid false signals, please try to put the coil into the seawater to
adapt to the surrounding before turn the metal detector on.
●There might be a random noise when the battery is in a low battery
state.
●Try not to detect in the place where there is strong interference,
especially the projector, power station.
３