DR.ÖTEK MT-XR Benutzerhandbuch Seite 25

unchanged and exit PP mode. Then press the PP button again and
repeat the above operation. Until you move the search coil slightly,
where the strongest signal will be smaller. Now, the position of the
metal target has been locked. You can mark on the ground in the centre
of the open search coil, to facilitate easier digging.
9. You can choose other operation modes according to your needs and
experience. If there are more scrap metals in the detection area, you
can choose the DISC mode to eliminate metals that do not need to be
detected. To remind you once again, when detecting in the wild, due to
the impact of the ground condition, the discrimination indication and
depth indication will deviate. The composition, size and oxidation of
metals will affect the indication result. It is necessary for you to
consider these factors before choosing to eliminate a certain metal or
determine whether there are precious metals. So precious metals will
not be eliminated.
In fact, the sensitivity in non-motion mode is high, search metals
directly using non-motion mode is also a choice. In some regions, the
ground is too narrow to sweep the search coil, you could choose the
PINPOINT mode. In a severe mineralization or salinization region, you
could try to sweep using PINPOINT directly.
TROUBLE SHOOTING GUIDE
SYMPTOM
No power, no boot sound, and
the LCD screen has no indication.
1. Be sure that the batteries are
installed correctly.
2. Replace the batteries.
２１
SOLUTION