DR.ÖTEK MT-XR Benutzerhandbuch Seite 26

Sound a successive "DI" "DI" tone 1. Make sure that there is no
The LCD displays normally, but
the unit has
function.
The LCD displays normally, but
the sensitivity is very low.
Sound tone is irregular or the
target identification cursor shows
quick, multiple results.
The signal is unstable, and the
position of
identification cursor changes.
no detection
the target
２２
other metal detector operating in
the area.
2. Adjust the sensitivity correctly.
The connection to the search coil
is poor. Check the cable is Plugged
in correctly.
When turning on, there may be
metal near the search coil. Ensure
the search coil is distant from the
ground, and then turn on the unit
again.
1. Don't use indoors as there are
many metals present.
2. Make sure
electromagnetic
source, such as power lines,
cables, electronic fences, and so
on. Keep away from these areas,
or try to reduce the sensitivity.
1. Sweep at a different angle, in
order to determine whether you
can get a more stable signal.
2. If the target is buried deeply,
you can try to increase the
sensitivity or speed up the sweep
of the search coil, in order to get a
more stable signal.
3. Perhaps more than one metal
target is present, try to increase
the sensitivity or set a different
discrimination range to sweep.
there is no
interference