DR.ÖTEK MT-XR Benutzerhandbuch Seite 18

c. If you want to search other metal materials, press the "MODE"
button again. The MEMORY cursor still lights up, and still shows the
same as Fig.12. Then repeat the above operation.
d. To quit the MEMORY mode, press the MODE button, making the
detector return to the state in Fig.12. Press the MODE button again, to
quit MEMORY mode, and enter the next operation mode.
6. JEWELRY mode test
Press the MODE button again, the JEWELRY cursor is lit. The first target
cursor on the left is not present, showing that iron is eliminated. It only
responds to other metals. (See Fig.15, using 1 ￠ zinc coin as an
example)
Fig.15
7. PINPOINT mode test
a. Press the "P-P" button lightly, and the PP cursor lights and flashes.
The detector completes a balance reset, and the PP cursor stops
flashing. The identify cursor and digital cursor are extinguished, the
depth cursor is fully displayed, and the detector sounds a slight
single-frequency tone. (See Fig.16)
１４