Selve commeo Betriebsanleitung Seite 42

iveo initial operation/Setting
5.7. Group separation
A group is an assembly of several motors/receivers that can be controlled by one
transmitter/channel. This transmitter is deleted after the end of the group separa-
tion. During group separation, each motor/receiver will only once move randomly for
3 seconds within a period of time of approx. 2 minutes. Stopping the motor with any
transmitter will programm this transmitter into the respective motor.
First press the STOP button and then the UP and DOWN buttons as well. Keep all
three buttons pressed for 9 seconds, in order to start the group separation (wait until
the transmitter control light flashes three times). The motor indicates activation of
group separation by a short run. Then each motor will move randomly for 3 seconds
within a period of about 2 minutes. Within the 3-second time slot, stop the move-
ment of the motor using the STOP button on the transmitter to be programmed.
Then the transmitter is programmed, and the motor has left the group separation
mode.
Fuse
3 s 3 s
Window 1 Window 2
3 s
Transmitter 1 Transmitter 2
If the motors/receivers are still moving together, repeat the proce dure for the
motors/receivers affected. If you did not programm a transmitter through the STOP
button and no other transmitter is programmed, you may programm this transmitter
again by pressing the UP and DOWN buttons at the same time and then pressing the
PROG button.
3 s
Window 3
3 s 3 s
Transmitter 3
Every motor/receiver moves randomly
only for 3 seconds within about 2 min-
utes. The motor/receiver in question
must be stopped by the selected trans-
mitter during the movement.
42
9 s