Selve commeo Betriebsanleitung Seite 37

commeo initial operation/Setting
Note for settings under point 4.2.: The motor/receiver must be selected for this set-
ting with a transmitter in SELECT mode (Status LED flashes slowly in orange). After
completing the setting, the motor/receiver is still selected (see point 4.).
4.2.4. Reset the receiver to the factory setting
To reset a receiver to factory settings, push the PROG button on the trans-
mitter for 9 seconds. All settings are reset to factory settings. There are no
transmitters and end positions saved in the motor anymore! The pro-
9 s
grammed receiver has been cancelled in the transmitter.
Note: This causes an error message if there are any more programmed receivers!
If this receiver in operating mode moves over a transmitter which is still pro-
grammed, the transmitter will no longer receive a response and will acknowledge
this with an error message.
4.2.5. CONFIGURATION mode (only for authorised qualified personnel)
In configuration mode, you can set the functions of the radio drives and receivers.
The functions that can be set depend on the type of drive/receiver. You can find
more detailed information on configuration mode in the document 'Configuring
radio drives and receivers', which is available to download at www.selve.de
4.3. Transmitter functions
The transmitter and receiver are in operating mode.
Intermediate positions
For setting and calling the intermediate positions, see the transmitter instructions.
9 s
Deleting the receiver list in the transmitter
To delete the receiver lists from a transmitter, push the SELECT
and PROG buttons at the same time for 9 seconds. Then all
receivers are deleted from the transmitter.
37
EN