Programming Transmitters/Channels; Programming Further Transmitters/Channels; Deleting Of Transmitters/Channels; Intermediate Positions - Selve commeo Betriebsanleitung

iveo initial operation/Setting

5.1. Programming transmitters/channels

5.1.1. Programming further transmitters/channels

Press the PROG button of a programmed transmitter/channel for 3 seconds (wait for
confirmation run from the motor/receiver). The motor/receiver is now in programme
mode for 1 minute. Press (1 sec.) the PROG button of the new transmitter/channel.
The new trans mitter/channel has now been programmed.
Programmed
transmitter/channel
3 s

5.1.2. Deleting of transmitters/channels

Press the PROG button of a programmed transmitter/channel for 3 seconds (wait for
confirmation run from the motor/receiver). The motor/receiver is now in programme
mode for 1 minute. Press (1 sec.) the PROG button of the transmitter/channel you
wish to delete. The transmitter/channel has now been deleted.
Programmed
transmitter/channel
3 s

5.2. Intermediate positions

For setting and calling the intermediate positions, see the transmitter instructions.
New
transmitter/channel
1 s
Transmitter/channel
to be deleted
1 s
39
EN