Reprogramming If A Transmitter Is Damaged Or Lost; Resetting To The Delivery Status - Selve commeo Betriebsanleitung

iveo initial operation/Setting

5.5. Reprogramming if a transmitter is damaged or lost

Only use if a programmed transmitter is no longer available (damaged or lost)! In
order to program a new transmitter, the receiver has to be put into reprogramming
mode by disconnecting it from the mains supply. Subsequently press the PROG but-
ton of the new transmitter for 3 sec. All the old transmitters have been depro-
grammed.
Fuse
3 s 3 s

5.6. Resetting to the delivery status

To return the receiver to the state at delivery, the receiver must be brought into ser-
vice mode by disconnecting it. Then press the PROG button of an assigned transmit-
ter for 9 seconds.
The receiver will then have no transmitters or limit positions saved.
Fuse
3 s 3 s
New transmitter
3 s 3 s
Assigned transmitter
3 s 9 s
41
EN