Selve Commeo/Iveo Radio - Selve commeo Betriebsanleitung

General

2.2. SELVE commeo/iveo radio

All SELVE commeo Receive Connect/Receive Connect Awning receive radio signals on
868.1 MHz (commeo radio) and 868.3 MHz (iveo radio). The two radio systems can
not be operated at the same time.
commeo is a bidirectional radio system that saves data in the receiver as well as the
transmitter. iveo is an unidirectional radio system which is compatible with the
intronic radio system. The receiver is compatible with both radio systems after it has
been disconnected from the mains supply as long as the teaching process for a com-
meo/iveo transmitter has not already been completed. If you wish to change the
radio system retrospectively, the programming for all transmitters of the other radio
system must be re-programed. The receiver must then be disconnected from the
mains supply. All SELVE commeo/iveo transmitters can be programmed into these
receivers. Up to 16 transmitters can be programmed into one motor. Please adhere
to the transmitter operating instructions.
The commeo receiver can be set for different applications in the CONFIGURATION
mode. The commeo Receive Connect/Receive Connect Awning is already set for
'venetian blind' or 'awning'.
To operate the commeo receiver, it is necessary to set the runtime of the blind. The
runtime is not set from the factory. An error message appears in the operating mode.
During iveo operation a change of the receiver application is not possible.
Note: Ensure that the controls are not installed and operated in the vicinity of metal
surfaces or magnetic fields. Metal surfaces or panes of glass with a metallisation
within the transmission path can reduce the range considerably.
Radio sets transmitting at the same frequency could interfere with reception.
It should be noted that the range of the radio signal is restricted by legislation and
constructional measures.
30