HMS LOOP14 Bedienungsanleitung Seite 29

1. The setting of user customized program:
At the standby state, press continually"
want, press" mode" button to confirm and enter setting, then can set the first period of time, when the user
sets, use handrail speed button to set speed,use handrail incline button to set incline, press"
finish the first period time of setting and enter into the second time to set until finish the 10 periods' setting; After
finishing the setting, the data will be saved permanently until the resets the next time, the data will not be lost
because of power outage.
2.The starting of user customized program.
Press continually " program" button at the standby state until the wanted user customized program(U1-U3),then
set the operation time and press "
3.The user customized program setting instruction
Every program divide the time into 10 spans, when the user sets, need to set the speed 、incline and time of the 10
spans before he press the start button to start the treadmill.
Eight, AUX
After the power is on, connecting the aux to other audio device can play music, after the treadmill power down
and enter into sleep mode, the music also will be closed, pressing any key can wake it up.
Nine, USB interface
Doesn't have audio playing function, only with charging function.
Ten, Metric Inch system change
Press " start" button, take off safety key, then connect the safety key, can enter into metric and Inch system switching,
distance/ mode window display, press right sides handrail buttons can choose metric and Inch system ("SI" signify
metric system, "Eng" signify Inch system),after choosing, press start button to confirm and drop out to standby state.
Eleven, Safety lock function：
1. Press " stop" button and "
state;
2. When the parameter setting display parameter numbers 0-9,use "
buttons both sides" to modify the values;
3. Parameters
Setting no.
1
2
3
4 Speeding up time/kilometers
5 Speeding down time/kilometers
6 low speed transmission ratio
7 middle speed transmission ratio
8 High speed transmission ratio
9 Automatic transmission ratio
Twelve, Safety lock function：
In any state, pulling off the safety lock can stop the treadmill from running immediately, when the treadmill stop
urgently, the buzzer make a long sounding, display panel display "SAFE"; at this moment, can not do any other
operation on the treadmill except turning off, after the safety lock is put on again, the treadmill enters into standby
state, wait to input orders.
program" button to the user customized program(U1-U3) that the user
start" button to start.
speed3" button, then put on the safety lock, enters into control panel parameter setting
Parameter definition
Lowest speed
Highest speed
Highest incline
start" button to turn and confirm, use "handrail
Setting range
3～30
80～250
12～20
2～200
2～200
100～2000
100～2000
100～2000
0～6000
mode" button,
remark