HMS LOOP14 Bedienungsanleitung Seite 25

Safety use attention
Only the treadmill had finished the installation and put on the motor protect cover, you can plug in the power. Put the
power line plug into the power socket which should be with the safety grounding line(16A), we suggest fit on over current
protector to ensure the safety of the user and the treadmill.
1. Place the treadmill at the place where is convenient for plug in the power, do not ward off the socket on the wall.
2. Never remove the protective cover casually, if need to open, PLS be sure to unplug the power line.
Belt middle placement and tightness adjustment
It is very necessary to adjust the belt to the best condition for the better use of the treadmill and the treadmill can work
better.
Belt Middle Placement
Put the treadmill running belt at the center:
Put the motorized treadmill on the level ground. let the treadmill run at the speed of 6-8 miles per hour, observe the
running belt deviating condition.
If the running belt deviate to the right, pull off the safety key and unplug the power, turn the right side adjusting bolt
clockwise by 1/4 circle, plug the power ,safety key, make the treadmill run, watch the running belt deviating condition.
Repeat the above steps, until the running belt is in the middle. Picture A
If the running belt deviate to the left, pull off the safety key, unplug the power, turn the left adjusting bolt clockwise by 1/4
circle, plug the power, safety key, make the treadmill run, watch the deviating condition of the
above steps, until the running belt goes to the middle. Picture B.
After the above adjustment or a period of time's use, running belt would become loosen, need adjustment. Pull off the safety
key, power switch, and turn the left and right adjusting bolt clockwise by 1/4 circle, plug power, safety key, make the treadmill
run, then stand on the treadmill to confirm the tightness. Repeat above steps, until the running belt is moderate in tightness.
picture C.
Ploy V-belt looseness and tightness
A If the running belt doesn't stop when you press it, the running belt and motor belt is not flabby or not tight.
They are just right;
B If the running belt stops when you press it, but the motor belt and the front roller don't stop, the running belt
is a little loose, then you need to adjust the running belt for the safe use(to adjust running belt loose and
tightness see the maintenance guideline in the before page);
C If the running belt and motor belt stop when press the running belt, the motor still run, the motor belt is
flabby, you need to adjust it for the safe use.
running belt. Repeat the