Lenz Digital plus LF100XF Information Seite 42

42
4 Not used
5 Gyrolight
6 Marslight
7 Strobe (flash)
8 Double strobe (double flash)
Bits 5 to 8 are only effective when bit 1 is also set. If more than one of
these bits is set, the higher bit is effective.
0-255 Determines the brightness while dimming output A.
52
255 is maximum brightness, 0 is off.
Flashing for outputs C and D
53
1 1
2 1
3 1
Bit Allocation of functions for output C
54
With this CV you determine to which function the function output C of
your decoder should react. If, for example, bit 1 is set in this CV, output
C will react to function 1 (e.g. on key 1 of LH100). You may also set
several bits. If, for example, bit 1 and 4 are set, the output will react to
both function 1 and function 4.
For Ditch light, this CV determines the function with which the flashing
is switched on.
Function output C flashes when activated
Function output D flashes when activated
Function outputs C and D flash alternately when C and D have
been deactivated beforehand (e.g. with key of LH100) and F2 is
activated additionally. If this bit is set, bits 1 and 2 should be
deleted!
Information LF100XF
0
0
0
0
0
[64]
0
0
0
0
[1]