Lenz Digital plus LF100XF Information Seite 28

28
Important safety instructions
The function decoder LF100XF is to be used only with Lenz DIGITAL plus or other standard
digital controls with an NMRA-compatibility seal. If in doubt, ask the system supplier.
Note the maximum current-carrying capacity of the decoder outputs. Make sure that the
maximum current-load is not exceeded. Exceeding this will destroy the decoder! The parts of the
locomotive decoder must not on any account touch the metal components of the chassis or the
body of the locomotive. This would cause a short-circuit within the locomotive decoder which
would destroy it.
Never wrap the decoder in insulating tape as this would prevent the necessary air circulation
around the decoder. Instead, put insulating tape or something similar around the metal
components in the vehicle. By doing so you can avoid unintentional short-circuits without
depriving the decoder of air. Use double-sided adhesive tape to affix the decoder.
Features of the function decoder LF100XF
The LF100XF is used to switch functions in locomotives or coaches. A typical application is the
switching of lights in coaches as well as the front light of a driving cab vehicle which changes
depending on the direction of motion. The LF100XF has a special drive for driving cab vehicles
which are equipped with diodes. Furthermore, the LF100XF has numerous lighting effects:
Information LF100XF