Lenz Digital plus LF100XF Information Seite 41

38 Allocation of outputs A and B to the functions F4 to F12. The allocation
is carried out in accordance with the following table:
to
46 F 4
Output A 38/6
Output B 38/7
The number preceding the slash states the CV, the number after the
slash states the bit which is to be set in the CV. For example:
Output A should react to F8: Bit 6 should be set in CV 41.
Output B should react to F12: Bit 4 should be set in CV46.
If a bit is set in these CVs, the other settings for the outputs A and B
(from CV51 onwards) are ignored.
51 Settings for outputs A and B:
1 0
1
The following bits only influence output A:
2 Is only queried if bit 3 or 4 = 1
0
1
1
3 0
1
F 5 F 6
39/6 40/6
39/7 40/7
Output A and output B do not react depending on the direction of
motion. A is active if the locomotive drives forwards, B is active
when the locomotive drives backwards.
Outputs A and B are switched independently of each other:
Output A reacts to function 0, output B to function 1.
Function output A is always dimmed when bit 3 is set.
and bit 1=0: dimming with F1 on / off
and bit 1=1: dimming with F4 on / off
Dimming function for output A not possible
Function for output A can be dimmed
F 7 F 8 F 9
41/6 41/6 43/3
41/7 41/7 43/4
F 10 F 11 F 12
44/3 45/3 46/3
44/4 45/4 46/4
41
[0]
[0]
0
0
0