Argo SPHERA Gebrauchsanleitung Seite 34

WARNING!
Prior to carrying out any cleaning or maintenance, unplug the unit from the power socket.
1. Cleaning the air filter
When the air filter needs to be cleaned, "CL" appears on the control
panel display. The air filter must be checked at least once every two
weeks of operation. Operation with dirty or clogged filters always
causes a decrease in the efficiency of the air conditioner and can
cause serious problems. To remove the filter, unhook the rear grille
and then remove the filter following the direction of the arrows, pulling
it gently. Use a vacuum cleaner to remove dust. If this is not enough,
wash the filter with warm water and possibly neutral detergent, rinse it
with cold water and let it dry naturally before putting it back in place.
Once the filter has been reinserted, close the grille and resume using
the air conditioner.
2. Cleaning the casing
Use a soft damp cloth to clean the outer surface of the air conditioner.
Do not use excessively hot water, solvents, petrol or other aggressive
chemical compounds, talcum powder and brushes: they may damage
the surface or colour of the casing. Remove any stains using warm
water with a little neutral detergent. Do not pour water onto the air
conditioner to clean it: this may damage the internal components or
cause a short circuit.
3. Storage
When you do not envisage using the air conditioner for a long time, clean the filters before storing it away. Keep
the appliance in a vertical position at all times. Do not place any heavy objects on the top and, if possible, protect
the air conditioner with a plastic sheet.
4. Transport
Preferably keep the air conditioner in the vertical position when
transporting it. Should this not be possible, rest it on its right-hand
side; when it reaches its destination, immediately put the appliance
in the vertical position and wait at least 4 hours before using it in the
cooling mode.
5. For complete safety, regularly check the condition of the power cord; should it be damaged through use, contact
the Service Centre to replace it.
V 01/24
CARE AND MAINTENANCE
34