Cleanmaxx Z 00110 Gebrauchsanleitung Seite 22

EN
6. Place the device in an upright position. The joint (12) of the cleaning foot locks in
place in a vertical position. Place the device down on a surface that can be ex-
posed to hot steam as hot steam emerges from the cleaning foot shortly after
it is switched on!
7. Flip the I O On / Off switch (15) to position I. The red control lamp in the water level
indicator (14) lights up and indicates that the device is heating up.
8. Wait until the blue control lamp lights up and hot steam emerges from the cleaning
foot. Then hold the cleaning foot securely with your shoe, grab hold of the handle and
lower it gently towards the fl oor to release the locked standing position.
10. Check the water level indicator from time to time If the reservoir contains too little
water or no water at all, switch off the device (fl ip the I O On / Off switch to position O)
and fi ll the reservoir up again. NOTE: If the water reservoir is empty, the device
emits a loud humming noise. Top up the water immediately to prevent damage
to the device!
11. When you have fi nished cleaning the fl oor or when you want to wash out the fl oor
cloth, switch off the device (fl ip the I O On / Off switch to position O) and pull the mains
plug out of the plug socket. Always pull the plug and never the cable!
12. Wait for a few minutes until the device has cooled down before you remove the fl oor
cloth. Please note that when you park the device a wet patch can form beneath
the cleaning foot.
22
9. Slide the cleaning foot slowly across the fl oor. The fl oor is
cleaned as you do this. When you rotate the handle, the
cleaning foot is rotated to the left and right.