10. Maintenance Accessories And Products; 10.1 Maintenance Products; Intenza+ Water Filter - Gaggia Anima Bedienungsanleitung

Behaviour
The machine grinds the
coffee beans, but coffee
does not come out.
Coffee comes out slowly.
The machine takes too
much time to heat up
or the quantity of water
dispensed is insufficient.
The frothed milk is too cold. Cups are cold.
Milk does not froth.

10. Maintenance accessories and products

10.1 Maintenance products

10.2 INTENZA+ water filter

Cause
Water empty.
The brew group is dirty.
The circuit is not primed.
The coffee dispensing spout is dirty.
The machine must perform the self-
adjustment.
Coffee is ground too finely.
The circuit is not primed.
The brew group is dirty.
The machine must perform the self-
adjustment.
The machine circuit is clogged by
limescale.
The milk frother is dirty or incorrectly
placed.
The type of milk used is not suitable
for frothing.
To clean and descale the machine use exclusively Gaggia maintenance products.
Should it prove difficult to find the machine maintenance products, please contact the
nearest Gaggia hotline in your country. Contacts are included in the warranty booklet
supplied separately or can be found at www.gaggia.com.
Product
• Descaling solution
• INTENZA+ water filter cartridge
• Brew group grease
• Degreasing tablets
• Milk circuit cleaning system
• Maintenance kit
It is recommended to install the INTENZA+ water filter that limits limescale formation
inside the machine and improves the aroma of your coffee.
Water is a fundamental component of coffee brewing: this is why it is essential to filter
it professionally. The INTENZA+ water filter can prevent the formation of mineral
deposits and improve water quality. It is sold separately.
Fill the water tank and prime the circuit again as
described in the "5.2.1 Water circuit priming" chapter.
Clean the brew group as described in the "7.2.1
Weekly brew group cleaning cycle" chapter.
Prime the circuit as described in the "5.2.1 Water
circuit priming" chapter.
Clean the coffee dispensing spout and its holes using
a toothpick.
Brew a few cups of coffee.
Change coffee blend or adjust the grinding as
described in the "5.3.3 Ceramic coffee grinder
adjustment" chapter.
Prime the circuit as described in the "5.2.1 Water
circuit priming" chapter.
Clean the brew group as described in the "7.2.1
Weekly brew group cleaning cycle" chapter.
Brew a few cups of coffee.
Descale the machine as described in the "7.5
Descaling cycle" chapter.
Warm the cups with hot water.
Clean the milk frother as described in the "7.4.2
Weekly cleaning of the milk frother components" and
insert it in the machine as shown in the "6.2 Milk
frother" chapter, "Inserting phase".
Read the "6.3 Milk- and coffee-based preparations"
chapter.
MAINTENANCE PRODUCTS
Action
ENGLISH
19