Part 2: Installation - Involight Trinity150Led Bedienungsanleitung

Part 2: Installation.

Unpack the device and carefully check for damages before using it. Place the unit in a suitable place or hang it on a
suitable crossbar. For suspended installation, the device must be secured with an approved safety rope. In addition,
the mounting bracket must be screwed with the enclosed screws and tightened! Then connect the device to the mains
and, if necessary, connect a DMX cable and connect it to other devices or a DMX controller. More about DMX or Master
/ Slave operation also in part 3 and 4.
During installation, provisions of the BGV C1 (formerly VBG 70) and DIN 15560 must be observed! Authorized
specialists may only carry out the installation!
IMPORTANT! Overhead mounting requires a lot of experience. This includes knowledge of the load bearing capacity,
the installation material used and the safety inspections of the material and the projector used, but the required
experience is not limited to this. If you do not have the appropriate qualification. Instead, commission a professional
installer. Incorrect installation may result in personal injury and / or damage to property.
Possible damage due to movement of the device.
NOTE!
Make sure there is enough room around the device for the movement of the head (pan,
tilt).
26