Abus RWM450 Bedienungsanleitung Seite 23

On the master already set up:
1. Press black activation pin into
marked opening and hold until LED
lights yellow
2. Pull back activation pin, then:
LED
1 second
Signal: short yellow pulse (lights
only very briefly)
Meaning: Testing in progress,
please wait!
LED
3 seconds
Signal: green steady signal
Meaning: Master function is now
on
LED
1 seconds
Signal: long yellow intervals
(slow)
Meaning: Networking mode
(for approx. 10 minutes)
You now have 10 minutes in which
to activate the connection mode of
an additional alarm and so to extend
the radio group. With each further
RISA added, this period extends by a
further 10 minutes for all devices.
Setting up other RISAs; Connection
Mode and creating a Radio Group
Remove the black activation pin
(which also acts as activation protec-
tion); but this will still be needed.
Press red activation button
Beep 1x
LED
1 second
Signal: short yellow pulse
(lights only very briefly)
Meaning: Testing in progress,
please wait!
– 44 –
LED
3 second
Signal: green steady signal
Meaning: Connection has been
established with at least one RISA.
LED
1 second
Signal: short yellow pulse
(lights only very briefly)
Meaning: Connection mode active;
additional RISAs can be
added to the radio group
For this see section: Setting up other
RISAs; Connection Mode and Creating
a Radio Group
If LED then lights red:
• Alarm is outside radio range of
other devices
• Indirect connection via repeating or
routing also not possible
• Time allowed for connection mode
has expired
If this occurs please check:
• Are other alarms still in connection
mode (LED flashing yellow at
regular intervals) ?
• If not: see section "Extending the
Radio Group, Entering Connection
mode and Repeat Connection
Attempts".
Completing Setup of Radio Group
Setup of the radio group is auto-
matically ended 10 minutes after
activation of the last planned alarm.
After this, none of the units' LEDs
give any signal. Connection mode
can also be ended immediately by
briefly pressing the radio button with
the black activation pin on any alarm
within the group. This causes the LEDs
of all devices to go out.
Radio Group Function Test
Press and hold the Test/Stop button
for 2-3 seconds to invoke a self-test
on this device:
Beep 1x
Press for 2 – 3 seconds
– 45 –
GB