Saeco Incanto HD8911 Bedienungsanleitung Seite 33

Problem
The AquaClean filter icon
does not appear on this
display after I replaced
the filter.
The AquaClean filter is
installed, but the
descaling message
appears.
The descaling message
appears before 8
AquaClean filters were
replaced.
The AquaClean filter does
not fit.
There is water under the
machine.
Cause
You did not confirm activation via the
machine menu.
You have not activated the
AquaClean filter via the menu.
You did not activate the AquaClean
filter correctly during first installation.
You placed the AquaClean filter after
having used the machine for a while.
You did not activate the replacement
filter in the machine menu.
You did not replace the filter when
the filter symbol started flashing.
You need to remove air from the
filter.
There is still water in the water tank.
You try to install another filter than
the AquaClean filter.
The rubber o-ring is not attached to
the AquaClean filter.
The drip tray is too full and
overflowed.
The machine is not placed on a
horizontal surface.
English
Solution
Confirm the activation of the filter
via the machine menu (see
'Activating the AquaClean filter '). If
the display shows 'START CALC
CLEAN' you first need to descale
the machine. Remove the
AquaClean filter before you do
and reinsert it afterwards.
First descale the machine and
then install a new AquaClean filter.
This will reset the filter counter to
0/8. Always confirm filter
activation in the machine menu
(see 'Activating the AquaClean
filter '), also after filter
replacement.
First descale the machine and
then install a new AquaClean filter.
Always confirm filter activation in
the machine menu (see 'Activating
the AquaClean filter '), also after
filter replacement.
Let air bubbles come out of the
filter.
Empty the water tank before you
install the filter.
Only the AquaClean filter fits into
your machine..
Check the packaging for the o-ring
and attach it to the AquaClean
filter.
Empty the drip tray when the 'drip
tray full' indicator pops up through
the drip tray. Always empty the
drip tray before you start descaling
the machine.
Place the machine on a horizontal
surface so that the 'drip tray full'
indicator works properly.
33