Saeco Incanto HD8911 Bedienungsanleitung Seite 32

English
32
Problem
The frothed milk is too
cold.
The milk does not froth.
The AquaClean filter
cannot be activated as the
tick does not appear on
the display.
The AquaClean filter
cannot be activated and
the machine asks for
descaling.
Cause
The cups are cold.
The classic milk frother is dirty or not
assembled correctly.
The type of milk used is not suitable
for frothing.
A filter has just been activated.
You have already replaced 8
AquaClean filters. After 8 filter
replacements you need to descale
the machine.
The filter has not been replaced in
time after the AquaClean water filter
signal flashed and the capacity
dropped to 0%.
The filter has not been installed
during first installation but after
having brewed approx.50 coffees
(based on 100ml cups). The machine
has to be completely limescale-free
before installing the AquaClean filter.
The new or replaced AquaClean filter
was not activated via the machine
menu. Also after replacing the filter,
you need to confirm activation via
the machine menu.
Solution
Warm the cups with hot water.
Clean the classic milk frother and
make sure it is correctly assembled
or installed.
Different types of milk result in
different amounts of froth and
different froth qualities. We have
tested the following milk types
which proved to deliver a good
milk froth result: semi-skimmed or
full-fat cow's milk, soy milk and
lactose-free milk. Other types of
milk have not been tested and
may result in a small amount of
milk froth.
You have to dispense at least 10
cups (of 100ml each) before you
can activate a new filter. Be careful
when you activate a new filter; the
filter counter will increase
automatically.
Descale your machine first and
then install the filter. Always
activate the AquaClean filter in the
menu (see 'Activating the
AquaClean filter '). Also do this
when you replace the filter.
Descale your machine first and
then install the filter.
First descale the machine and
then install a new AquaClean filter.
After descaling, the filter counter is
reset to 0/8. Always confirm filter
activation in the machine menu.
Also do this when you replace the
filter.
Descale your machine first. Then
activate the AquaClean filter in the
menu (see 'Activating the
AquaClean filter '). Also do this
when you replace the filter.