Saeco Incanto HD8911 Bedienungsanleitung Seite 12

English
12
STRENGTH
INSTALL
FILTER
ON
OFF
0 / 8
8 Place a container under the classic milk frother. Press the OK button to
start the water circuit priming cycle.
-
The machine starts dispensing hot water.
-
The display shows the priming icon. The progress bar shows the
progress of the priming cycle.
9 The machine heats up and the display shows the temperature icon.
10 Empty the container and place it under the coffee dispensing spout.
11 The machine starts rinsing water through the coffee dispensing spout.
The display shows the rinsing icon and a progress bar.
Note: Do not interrupt the rinsing cycle.
12 The display asks: AquaClean filter?
Note:If you want to install the AquaClean filter afterwards, press the ESC
button and continue with the manual rinsing cycle. For installation see
chapter 'AquaClean filter'.
13 If you want to install the AquaClean filter, press the OK button. Activation
will take 2 minutes.
- The display reminds you to install the filter.
14 Remove the AquaClean filter from its packaging. Shake the filter for about
5 seconds.
15 Immerse the AquaClean filter upside down in a jug with cold water and
wait until no more air bubbles come out.
16 Insert the AquaClean filter vertically onto the filter connection. Push the
AquaClean filter to the lowest possible point. Make sure that the filter fits
tightly and the seal is in the right position, to guarantee the best
performance.
17 Fill the water tank with fresh water to the MAX level indication.
18 Select ON on the display and confirm the activation by pressing the OK
button.
-
When activation is finished, the display shows a tick to confirm
activation.
-
The machine starts heating up automatically.