Miele PDR 914 HP Kurzgebrauchsanweisung Seite 149

The clamping lug connects the heat-pump to the tumble dryer. Once
this step is complete, the tumble dryer should no longer be able to
move away.
Put the tumble dryer lid on top of the tumble dryer and clamp the

upper clamping lug of the heat-pump beneath the tumble dryer lid.
Then firmly screw on the tumble dryer lid.

Tumble dryer
a
Installation
Place the heat-pump dryer on a totally level, secure and horizontal

surface that is able to withstand the specified floor load.
The floor load created by the heat-pump dryer is concentrated and
transferred to the installation footprint via the machine feet. A base is
not required. However, an uneven floor surface must be com-
pensated for.
Place the heat-pump dryer as close as possible to a cold water con-

nection so that you can easily clean the heat exchangers with a
hose, if required (water pressure up to a maximum of 4 bar is per-
mitted).
en - Installation
Heat-pump
b
149