Miele PDR 914 HP Kurzgebrauchsanweisung Seite 147

At the next installation site, the tumble dryer and the heat pump must
be lifted off the transport pallet using suitable lifting gear.
Installing the heat-pump
Before the heat-pump dryer is used for the first time, the tumble dryer
and heat-pump must be connected with one another. The following
steps describe how to install the heat-pump on the tumble dryer:
Firstly, set up the heat-pump at the designated installation site.

When installing the heat-pump dryer, please note that the specified
minimum distance from the wall of at least 500 mm must be ob-
served.
The air intake vent and the condensate drain are found on the back
of the heat-pump.
Before installation, position the heat-pump at the installation site in
such a way that the air intake vent and the condensate drain are not
pointing in the direction of the tumble dryer.
Position the tumble dryer parallel in front of the heat-pump, leaving

a little distance between the two. The rear of the tumble dryer must
be facing the heat-pump.
Remove the tumble dryer lid.

Feed the electrical connection cable through the heat-pump and

connect it to the tumble dryer (see Electrical connection).
Insert the plug into the socket on the tumble dryer.

en - Installation
147