Electrolux SG2500NOP Benutzerinformation Seite 71

Problem
A rectangular symbol is
shown instead of numbers
on the Temperature Dis-
play.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Water flows on the floor.
Temperature cannot be set. The FROSTMATIC or
Possible cause
The temperature in the
appliance is too high.
Temperature sensor prob-
lem.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The FROSTMATIC func-
tion is switched on.
The door is not closed
correctly or the gasket is
deformed/dirty.
This is normal, no error
has occurred.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
ShoppingMode function is
switched on.
ENGLISH
Solution
Contact a qualified electrician
or contact the nearest Au-
thorized Service Centre.
Contact the nearest Author-
ized Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Contact the nearest Author-
ized Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FROSTMATIC func-
tion".
Refer to "Closing the door".
The compressor starts after a
period of time.
Attach the melting water out-
let to the evaporative tray.
Switch off FROSTMATIC or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FROST-
MATIC or ShoppingMode
function".
71