Connection And Operation - Migatronic Rwf2 Betriebsanleitung

Connection and operation

Warning
Read warning notice and
instruction manual carefully
prior to initial operation and
save the information for later
use.
Connection
11 10
AIR Clean
Max.8 bar
9 2 1 6
1. Compressed air connection - (not all models)
AIR Clean (max 8 bar) – Inlet
2. Compressed air connection - (not all models)
AIR Clean (max 8 bar) – Outlet
3. CAN-plug
4. Gas connection
5. Power +
6. Torch cooling connection (not all models)
7. Status indicator
8. Wire inlet
9. Torch connection
10. Collision protection signal to robot controller
11. Torch collision protection and touch sense
connection
Important!
In order to avoid destruction
of plugs and cables, good
electric contact is required
when connecting earth cables
and intermediary cables to the
machine.
7 3 8
Min 2 bar
Max 6 bar
6 4 5
Cable dimensions
Welding current DC
200 A 35 mm²
300 A 50 mm²
400 A 95 mm² / 2x50 mm²
500 A 2x70 mm²
Welding process Distance to
work piece
MIG - IAC and pulse 10 m
MIG - non pulse 30 m
a
WARNING
When you activate the torch trigger,
there is voltage applied to the
welding wire.
Note!
Use rubber feet (45070026) as galvanic separator
between the RWF² casing and the unit on which it is
mounted.
7
PULSE
35 mm²
70 mm²
95 mm² / 2x50 mm²
2x70 mm²
Total cable length
in welding circuit
(a+b) (a+b+c)
20 m
60 m
b
c