Werbung
Verfügbare Sprachen
Verfügbare Sprachen
►Self-cleaning recharger
Problem
The system outer foil
has not been
thoroughly washed.
The system outer foil
is not dry or is sticky.
Action
If the shaver is not cleaned
for more than 2 weeks, first
clean with the cleaning
brush to remove beard
trimmings.
(See page 21.)
Do not add detergent and
water except when
replacing the cleaning liquid.
Doing so may deteriorate
the cleaning function.
(See page 22.)
After cleaning, oil‑like
droplets may remain on the
outside of the foil frame.
This is the lubricating
component of the cleaning
liquid and does not indicate
a problem. You may wipe it
off with a soft cloth.
The system outer foil may
not dry quickly due to
temperature conditions.
Run the "Dry/Charge" mode
again or wipe with a soft
cloth before shaving.
Problem
The system outer foil
cracks or deforms
during cleaning.
The cleaning liquid
has foamed.
Cleaning liquid has
accumulated in the
cleaning tray.
Action
Do not insert any foreign
objects into the recharger.
Remove foreign objects in
the cleaning tray. (See
page 22.)
Replace the system outer
foil. (See page 21.)
If you mix soapy water or
hand soap with the
detergent or use another
detergent, the cleaning
liquid will foam. Use the
self‑cleaning recharger after
thoroughly washing and
drying the shaver.
Replace the cleaning liquid.
(See page 22.)
Remove any waste, etc. that
has accumulated in the
drain at the bottom of the
cleaning tray.
(See page 22.)
If you use the self‑cleaning
recharger when the shaver is
wet or when soap or shaving
gel is on the shaver, cleaning
liquid may accumulate in the
cleaning tray.
25
Werbung
