Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MAINTENANCE / SERVICING
Regular cleaning/maintenance increases the service life of your
appliance.
Inspect your treadmill regularly and tighten loose parts if
necessary. Replace worn parts immediately.
CLEANING
Warning: To prevent electric shocks, check that the appliance is
unplugged before you start cleaning.
Important: Do not use abrasive cleaners or solvents to clean
your treadmill. To prevent damage to the computer, keep it
away from any liquids and never expose it to direct sunlight.
After each training session: Wipe the computer console and
other surfaces of the treadmill with a clean, damp, soft cloth to
remove training sweat.
Weekly: Dust and dirt from the environment gets under the
treadmill. Therefore, vacuum around and under the treadmill
every week.
Every six months: The running engine sucks dust into the engine
compartment and can clog the engine. Open the hood approx.
every 6 months and carefully vacuum out the engine
compartment and engine.
TREADMILL LUBRICATION
The running mat is pre-lubricated. We recommend that you check
the lubrication of the running mat regularly to ensure optimum
operation.
Check the lubrication of the running mat every 30-40 days: To
do this, lift the sides of the treadmill and feel the surface of
the running deck with your fingers. If you feel traces of
silicone, lubrication is not necessary.
When the surface is dry, proceed as follows when lubricating:
3.
Apply silicone oil under the running mat by lifting it a few
centimeters; repeat the process on the other side.
4.
Switch on the appliance without ascending and let the belt
run at minimum speed for 5 minutes.
Only use silicone oil that does not contain any petroleum
components.
B
51
OPERATING INSTRUCTIONS
TENSIONING THE RUNNING MAT
If the running mat slips or if you feel it falter during individual
steps, it is necessary to increase the tension.
Turn the left rear screw 1/4 turn clockwise.
Repeat step 1 for the right-hand side. Make sure that you make
the same number of turns so that the roller is aligned with the
frame.
Repeat step 1 and step 2 until the running mat is so taut that it no
longer slips.
Take care not to tension the running mat too much, as this can lead
to excessive pressure on the ball bearings.
To reduce the tension of the running mat, turn both screws
anticlockwise the same number of times.
CENTERING THE RUNNING MAT
The forces that occur when running can cause the running mat to
shift slightly. This displacement is normal and the belt adjusts itself
when no one is standing on it. If it persists, manual intervention is
required.
Let the treadmill run without anyone running on it and increase
the speed to approx. 6 km/h
1. Check whether the belt has a tendency to the right or left.
If the running mat moves to the left, turn the left rear screw
clockwise ¼ turn at a time.
If the running mat moves to the right, turn the right rear screw
clockwise ¼ turn at a time.
If the belt is still not centered, repeat the above steps until the
problem is resolved.
2. Once the belt is centered, increase the speed and check that
the belt is running correctly in the middle of the deck.
Werbung
