Bcube A8 Plus Bedienungsanleitung Seite 51

Connection cable to motor defective or loose
Error message on
Motor defective
display
E-02
Controller defective
Speed sensor not correctly aligned
Error message on
Speed sensor defective
display
Speed sensor not properly connected to
E-03
controller
Controller defective
Motor overloaded
Error message on
display
E-05
Controller defective
Motor defective
The emergency stop safety key is not positioned
Error message on
correctly on the console
display
E-07
Emergency stop switch on console defective
Hand pulse cable not connected correctly
Hand pulse sensors defective
Console circuit defective
No heart rate display Chest strap sensors do not transmit signal
Chest strap battery empty
Chest strap defective
coded chest strap
B
50
OPERATING INSTRUCTIONS
Check the engine connection cable in the engine
compartment
Replace motor
Check connection cable between motor and controller in the
motor compartment. Replace controller if necessary
Check the alignment of the speed sensor on the engine in the
engine compartment
Replace speed sensor
Check the connection cable between the speed sensor and
controller in the engine compartment.
Replace controller in the engine compartment
Check the lubrication and tension of the running mat as
described in the assembly instructions; check for other causes
that could slow down the belt, such as defective rollers or
foreign objects
Replace controller in the engine compartment
Replace motor
Remove and reposition the emergency stop safety key
Replace console
Check cable connection with console
Replacing the hand pulse sensors
Replace console
Moisten sensors well
Replace battery
Replacing the chest strap
Use chest strap without coding