Signals On The Control Unit; Accessories - Nice Rd300 Anweisungen Und Hinweise Für Den Installateur

7.7.2) Signals on the control unit

On the ROAD200 control unit there is a set of LED each of which can
give special indications both during normal operation and in case of
malfunctions.
Table 21: LED's on the control unit's terminals
LED OK
Off
On
One flash every second
2 quick flashes
Series of flashes separated by
a second's pause
LED OK
Off
On
Table 22: LED's on the control unit's buttons
L1 LED Description
Off Correct during normal operation.
On Lit for 10 seconds means that the transmitter memorisation is being performed.
• Function programming in progress.
It flashes
• Radio transmitter cancellation or diagnostics..
L2 LED Description
Off Indicates slow "motor speed" during normal operation.
On Indicates fast "motor speed" during normal operation.
• Function programming in progress.
It flashes • If it flashes together with L3, it means that it the user must carry out the door opening and closing positions
recognition phase (refer to Paragraph "4.3 Recognition length of the leaf").
L3 LED Description
Off Indicates "Automatic Closing" is active during normal operation
On During normal operation the device indicates "Automatic Closing" is not active.
• Function programming in progress.
It flashes • If it flashes together with L2, it means that it the user must carry out the door opening and closing positions
recognition phase (refer to Paragraph "4.3 Recognition length of the leaf")

7.8) Accessories

For information on the complete range of accessories, refer to the
Nice s.p.a. product catalogue.
18
All manuals and user guides at all-guides.com
Cause ACTION
Make sure there is power supply; check to see if the fuses are blown; if neces-
Malfunction sary, identify the reason for the failure and then replace the fuses with others
having the same characteristics.
There is a serious malfunction; try switching off the control unit for a few sec-
Serious malfunction onds; if the condition continues it means there is a malfunction and the elec-
tronic board has to be replaced.
Everything OK Normal operation of control unit
The status of the inputs has This is normal when there is a change in one of the inputs: SEP-BY-STOP,
changed STOP, triggering of photocells or the radio transmitter is used.
Miscellaneous It corresponds to the flashing light's signal. See Table 20.
Cause ACTION
Activation of the STOP input Check the devices connected to the STOP input
Everything OK STOP Input active
27