Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating modes and configuration
7
Operating modes and
configuration
After pairing and mounting the device,
you can individually adjust the settings
to your personal needs via the confi-
guration menu. To do this, proceed as
follows:
• Press and hold down the control
wheel (E) to open the configuration
menu.
• Select the desired symbol by tur-
ning the control wheel and pres-
sing it briefly if you want to adjust
the settings of the following menu
items.
Press and hold down the control
wheel to get back to the previous
level. The menu automatically
closes without applying changes if
there is no operation for more
than 1 minute.
Please note that the device is
configured exclusively via the app
once the device has been paired
with the access point.
6.1
Automatic mode
6.2
Manual operation
6.3
Holiday mode
6.4 Operating lock
6.5
Programming of heating profiles
6.6
Date and time
6.7
Offset temperature
6.8
Selecting the desired tempera-
ture display
6.9
Configuring the floor heating
actuator
6.10
Communication test
7.1
Automatic mode
In automatic mode, the temperature is
controlled in accordance with the set
week profile
(see „6.5.3 Week profile"
on page
74). Manual changes that
are set via the control wheel (E) are
activated until the next point at which
the profile changes. Afterwards, the
defined heating profile will be activated
again. To activate the automatic mode,
please proceed as follows:
• Press and hold down the control
wheel (E) to open the configuration
menu.
• Select the
control wheel and confirm by pres-
sing the control wheel briefly.
7.2
Manual operation
In manual mode, the temperature is
controlled in accordance with the
current temperature set via the control
wheel (E). The temperature remains
activated until the next manual change.
To activate the manual mode, please
proceed as follows:
• Press and hold down the control
wheel (E) to open the configuration
menu.
• Select the
control wheel and confirm by pres-
sing the control wheel briefly.
• Turn the control wheel to set the
desired temperature.
You can fully close or open the
vale by turning the control wheel
(E) as far as it will go in an anti-
clockwise or clockwise direction.
"OFF" or "On" is displayed.
symbol by turning the
symbol by turning the
34
Werbung
