Toro Recycler 20961 Bedienungsanleitung Seite 7

Figure 6
1. Full
2. High
3. Carefully pour about 3/4 of the engine capacity of oil
into the oil-fill tube.
4. Wait about 3 minutes for the oil to settle in the engine.
5. Wipe the dipstick clean with a clean cloth.
6. Insert the dipstick into the oil-fill tube, then remove
the dipstick.
7. Read the oil level on the dipstick
•
If the oil level is below the Add mark on the
dipstick, carefully pour a small amount of oil into
the oil-fill tube, wait 3 minutes, and repeat steps
through 6 until the oil level on the dipstick is at the
Full mark on the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level is at
the Full mark on the dipstick; refer to
the Engine Oil (page
Important: If the oil level in the engine is too
low or too high and you run the engine, you may
damage the engine.
8. Install the dipstick securely.
g201460
3. Low
(Figure 6).
Changing
17).
4
Assembling the Grass Bag
No Parts Required
Procedure
1. Slip the grass bag over the frame as shown in
1
2
1. Handle
2. Frame
3
Note: Do not slip the bag over the handle
2. Hook the bottom channel of the bag onto the bottom
of the frame
6
3
Figure 7
3. Grass bag
(Figure 8).
Figure 7.
g027257
g027257
(Figure 7).