Toro Recycler 20961 Bedienungsanleitung Seite 12

Using the Self-Propel Drive
To operate the self-propel drive, simply walk with your hands
on the upper handle and your elbows at your sides, and the
machine will automatically keep pace with you
Note: If the machine does not freely roll backward after
self-propelling, stop walking, hold your hands in place, and
allow the machine to roll a couple of centimeters (inches)
forward to disengage the wheel drive. You can also try
reaching just under the upper handle to the metal handle and
push the machine forward a couple of centimeters (inches).
If the machine still does not roll backward easily, contact an
Authorized Service Dealer.
Shutting Off the Engine
Service Interval: Before each use or daily
To shut off the engine, release the blade-control bar.
Important: When you release the blade-control bar,
both the engine and blade should stop within 3 seconds.
If they do not stop properly, stop using your machine
immediately and contact an Authorized Service Dealer.
Recycling the Clippings
Your machine comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
If the grass bag is on the machine and the bag-on-demand
lever is in the bagging position, move the lever to the recycling
position; refer to Operating the Bag-on-Demand Lever (page
11). If the side-discharge chute is on the machine, remove it;
refer to Removing the Side-Discharge Chute (page
Bagging the Clippings
Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
If the side-discharge chute is on the machine, remove it; refer
to Removing the Side-Discharge Chute (page
(Figure
Figure 16
12). If the
bag-on-demand lever is in the recycling position, move it to
the bagging position; refer to
Lever (page
16).
Installing the Grass Bag
1. Raise and hold up the rear door
g009549
1. Rear deflector
2. Notches (2)
2. Install the grass bag, ensuring that the pins on the bag
rest in the notches on the handle
3. Lower the rear door.
Removing the Grass Bag
To remove the bag, reverse the steps in
Bag (page 11).
Operating the Bag-on-Demand
Lever
The bag-on-demand feature allows you to either collect or
recycle grass and leaf clippings while the grass bag is attached
to the machine.
•
To bag the grass and leaf clippings, press the button
12).
on the bag-on-demand lever and move the lever forward
until the button on the lever pops up
11
Operating the Bag-on-Demand
11).
Figure 17
3. Grass-bag pin (2)
(Figure 17).
g188382
(Figure 17).
Installing the Grass
(Figure 18).