Toro Recycler 20961 Bedienungsanleitung Seite 19

Figure 30
5. After draining the used oil, return the machine to the
operating position.
6. Carefully pour about 3/4 of the engine capacity of oil
into the oil-fill tube.
7. Wait about 3 minutes for the oil to settle in the engine.
8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick into the oil-fill tube, then remove
the dipstick.
10. Read the oil level on the dipstick
•
If the oil level is below the Add mark on the
dipstick, carefully pour a small amount of oil into
the oil-fill tube, wait 3 minutes, and repeat steps
8 through 10 until the oil level is at the Full mark
on the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level is at
the Full mark on the dipstick.
Important: If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
11. Install the dipstick securely.
12. Recycle the used oil properly.
g186134
(Figure 28).
18
Replacing the Blade
Service Interval: Yearly
Important: You will need a torque wrench to install the
blade properly . If you do not have a torque wrench or
are uncomfortable performing this procedure, contact
an Authorized Service Dealer.
Examine the blade whenever you run out of fuel. If the blade
is damaged or cracked, replace it immediately. If the blade
edge is dull or nicked, have it sharpened and balanced, or
replace it.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Wear gloves when servicing the blade.
1. Refer to Preparing for Maintenance (page
2. Tip the machine onto its side with the air filter up.
3. Use a block of wood to hold the blade steady
31).
Figure 31
4. Remove the blade, saving all mounting hardware
(Figure 31).
5. Install the new blade and all mounting hardware
(Figure 32).
16).
(Figure
g024442