Toro Recycler 20961 Bedienungsanleitung Seite 10

Checking the Engine-Oil Level
Service Interval: Before each use or daily
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Full
2. High
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick into the oil-fill tube, then remove
the dipstick.
5. Read the oil level on the dipstick
•
If the oil is below the Add mark on the dipstick,
slowly pour a small amount of oil into the oil-fill
tube, wait 3 minutes, and then repeat steps
through 5 until the oil level is at the Full mark on
the dipstick.
•
If the oil is above the Full mark on the dipstick,
drain the excess oil until the oil level is at the Full
mark on the dipstick. To drain the excess oil, refer
to Changing the Engine Oil (page
Important: If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
6. Install the dipstick into the oil-fill tube securely.
(Figure 11).
Figure 12
3. Low
(Figure 11).
17).
Adjusting the Cutting Height
CAUTION
If the engine has been running, the muffler will be
hot and can severely burn you.
Keep away from the hot muffler.
Adjust the cutting height as desired. Set all the cutting-height
levers to the same height. To raise and lower the machine,
refer to Figure
g201460
1. Raise the machine
Note: The cutting-height settings are 25 mm (1 inch); 35
mm (1-3/8 inches); 44 mm (1-3/4 inches); 54 mm (2-1/8
3
inches); 64 mm (2-1/2 inches); 73 mm (2-7/8 inches); 83 mm
(3-1/4 inches); 92 mm (3-5/8 inches); and 102 mm (4 inches).
During Operation
During Operating Safety
General Safety
•
Wear appropriate clothing, including eye protection;
slip-resistant, substantial footwear; and hearing
protection. Tie back long hair, secure loose clothing, and
do not wear jewelry.
•
Do not operate the machine while ill, tired, or under the
influence of alcohol or drugs.
•
The blade is sharp; contacting the blade can result in
serious personal injury. Shut off the engine and wait for
all moving parts to stop before leaving the operating
position.
9
13.
Figure 13
2. Lower the machine
g186259