Toro Recycler 20961 Bedienungsanleitung Seite 20

Figure 32
Important: Position the curved ends of the blade
to point toward the machine housing.
6. Use a torque wrench to tighten the blade bolt to
82 N∙m (60 ft-lb).
Important: A bolt torqued to 82 N∙m (60 ft-lb) is
very tight. While holding the blade with a block
of wood, put your weight behind the ratchet or
wrench and tighten the bolt securely. This bolt is
very difficult to overtighten.
Adjusting the Self-Propel Drive
Whenever you install a new self-propel cable or if the
self-propel drive is out of adjustment, adjust the self-propel
drive.
1. Turn the adjustment knob counterclockwise to loosen
the cable adjustment
g024443
1. Handle (left side)
2. Adjustment knob
3. Self-propel-drive cable
2. Adjust the tension on the cable
back or pushing it forward and holding that position.
Note: Push the cable toward the engine to increase
the traction; pull the cable away from the engine to
decrease the traction.
3. Turn the adjustment knob clockwise to tighten the
cable adjustment.
Note: Tighten the knob firmly by hand.
19
(Figure 33).
Figure 33
4. Turn the knob clockwise to
tighten the adjustment.
5. Turn the knob
counterclockwise to
loosen the adjustment.
(Figure 33) by pulling it
g027231