Rear Panel; Dinih Aura Dete Tie Detente Ation Manag Eae - Sony Rmo-S550 Bedienungsanleitung

Rear Panel
Fig. 1-3: Rear View
[1] SCSI Connectors
Plug SCSI cables linking the host computer and other SCSI peripherals
into these connectors. If the RMO-S550 is the last device on the SCSI
chain, attach the supplied terminator to the other SCSI connector on the
unit's rear panel.
[2] Air Filter
This air filter protects the internal mechanisms of the RMO-S550 from
dust and foreign matters. Be careful not to block the surface of this filter
or impede the inflow of air. The filter must be replaced periodically. Refer
to the section "Changing the Air Filter" on page 20 for details.
[3] F.GND (frame ground) Terminal
Connect the ground terminals of other devices to the unit's frame ground.
[4] AC IN (AC power connector)
Connect the supplied AC power cord to this connector.
[5] POWER Switch
Press the side of-the switch marked "1" to turn the unit on; and press the
side marked "O" to turn the unit off.
[6] DIP Switches :
Use these switches to set the RMO-S550's function and SCSI ID address.
Chapter 1 Introduction 9