AEG Protect C 1000 LCD+ Benutzerhandbuch Seite 68

68
4.3 Display functions
When starting the UPS, the display is in the default UPS status
summary screen.
Main menu Submenu
UPS status
Event log
Measurements
Go to Bypass
Load segment
Start
test
Reset
state
Control
Reset
list
Reset
card
Restore
factory
settings
Settings
Identification
Display information or Menu
function
UPS mode, date/time, battery status
and current alarms
Displays the events and faults stored
[Load] W VA A P%, [Input/Output] V Hz,
[Battery] % min V EBP, [DC Bus] V,
[Temperature] C
PUE, kWh
Transfers the UPS on Bypass mode
Load segment on/off
battery
Starts a manual battery test
fault
Clear active fault
event
Clear events and faults
com
Reset Modbus TCP function inside UPS
Restore to default factory settings
Refer to User settings
[Product name],
[firmware version], [IP/MAC address]
[Serial number],