Fine Parameter Adjustment In Quick Mode - Pce Instruments Pce-Les 103 Bedienungsanleitung

5.2.3

Fine parameter adjustment in quick mode

You can perform a fine frequency adjustment by pressing the Quick key. When the Quick key is
pressed, fine frequency adjustment mode will be activated. You will see a digit in the frequency
value highlighted in orange, as shown in figure 5.
Figure 31. Quick mode
You can then press the Up / Down keys to increase / decrease that digit by 1. Press the Right or
Left key to move through every digit of the value and adjust each digit. Once the desired value
has been entered, press the OK key and the device will be set to the entered frequency. Once
OK has been pressed, the next parameter (duty cycle) can be modified following the same
procedure as with the frequency.
Figure 32. Quick mode - duty cycle modification
You can modify the duty cycle now by pressing the Up/Down keys to increase/decrease each
digit and using the Right/Left keys to navigate to other digits. Press OK to confirm the entered
value for the duty cycle or press Back to return to frequency modification mode. If you press OK,
the next parameter (phase shift) can be modified in the same way as the two previous parameters.
© PCE Instruments
29