Torque Setting; Tool Change; Switching On/Off; Cleaning And Maintenance - Parkside PABS 20-Li E6 Originalbetriebsanleitung

Torque setting

You can preset the maximum torque by
rotating the torque adjustment ring (3).
25 torque settings + 1 drill setting are
provided.
1. Turn the adjusting ring (3) to select the
desired torque:
Step 1 -->
Step -->
Screws:
Drilling:
2. Start with a lower torque step and in-
crease according to requirement.
Torque adjustment should only be
performed in standstill mode.
Reaching the preset torque limit pro-
duces a noticeable rasping sound.
This sound is caused by the slip clutch.

Tool change

1. Rotate the keyless chuck (2) counter-
clockwise, until the drill chuck aper-
ture (1) is large enough to accommo-
date the tool.
2. Push the tool as far as possible into the
keyless chuck (2).
3. Rotate the chuck clockwise to clamp
the tool fi rmly.
4. To remove the tool again, rotate the
keyless chuck (2) and pull out the tool.
There is a bit holder (
magnet on the left and right of the
housing. You can attach one bit at
a time to the bit holder.
lowest torque,
highest torque.
Steps 1 - 25
Step .
5) with

Switching on/off

By using the on/off switch (12) you can pro-
gressively control the speed. The longer you
push the on-off button, the higher the speed.
1. Press the on/off switch (12) to start the
device. The LED work light (10) lights
up during operation.
2. To turn it off, release the on/off switch
(12). When you move the direction
switch (11) to the middle position,
the device is secured against being
switched on.
During breaks in work, the device
can be hung from a belt, using the
integral metal clip (
care to ensure that the device is
switched off and secured against
accidental activation.
The metal clip is also suitable for
opening bottles with bottle caps.
Cleaning and
maintenance
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.
GB
18). Take
25