Switching On The Controller; Controller Protection Functions; Tips And Suggestions For The First Flight; Environmental Informations - GRAUPNER 13400 Anleitung

Switching on the controller

1. Make sure that the throttle stick is always located on the motor stop position when you plug in the battery
2. Plug the battery to the connector of the controller, the motor plays a melody like "Do Re Mi"
EN
3. After 2 sec. the motor beeps with a long beep (B--), which means that the throttle stick is in the motor stop position
for a safe start
4. After 2 sec., the motor will beep in the tone of the set brake function
5. Now, the controller is ready to operate the motor

Controller protection functions

1. Start-up protection. If the motor within 2 seconds after the accelerator will not begin to rotate, the controller will shut
down to prevent an uncontrolled running. In this case, move the throttle stick to the stop position to reactivate the
controller. (This may be caused by: The connection to the motor is not correct, the propeller is blocked, etc.)
2. Overheat protection: When the temperature exceeds 110 ° C, the motor is limited
3. Motor stop in case of loss of the signal. If the signal is interrupted by the receiver longer than 1 sec, the motor
performance is reduced, longer than 2 seconds, the motor is switched off
4. If after plugging in the battery, the output tones are "Beep, Beep, Beep" (Every "Beep" has an interval of 2 sec.),
it means that the battery is over or under voltage
5. If after plugging in the battery, the output tones are "Beep, Beep, Beep" (Every "Beep" has an interval of 0.25 sec.),
it means that the throttle stick is not in motor stop position

Tips and suggestions for the first flight

• After you have assembled the model according to the instructions, programmed the remote control as specified,
all batteries are charged, the first flight will be possible.
• For the first flight there should be not too much wind.
• The construction of the model is very easy, the flight is very sophisticated.

Environmental informations

• This symbol on the product, user manual or packaging indicates that this product must not
• The materials are recyclable as marked. By material recycling or other forms of re-usage you are
• Batteries and accumulators must be removed from the device and disposed of at an appropriate
14
be disposed of with other household waste at the end of its life. It must be handed over to the
applicable collection point for the recycling of electrical and electronic equipment.
making an important contribution to environmental protection.
collection point. Please inquire if necessary from the local authority for the appropriate disposal site.
2015/02/12